Skip to main content

Ground Control Beta

Answer will appear here...

Back to top

How it works

Your Ai Pin automatically updates with the latest software as long as the following conditions are met:

  • Ai Pin + Booster placed on the Charge Pad.
  • Your Ai Pin is connected to a Wi-Fi network (not a mobile hotspot or metered network).
  • If Ai Pin has been powered off, you've unlocked it at least once since powering on.
  • Ai Pin and Battery Booster power levels are 80% or higher. (Tap the Charge Pad while Pin + Booster is on it. You will see a green light if power is 80% or higher.)

We recommend charging your Pin + Booster on the Charge Pad overnight to automatically receive software updates and avoid any interruptions during the process. 

Check for software updates

If there is an available over-the-air (OTA) software update, a "software update" message will appear at the top of the settings menu. To check for this message:

  1. Tap the touchpad with one finger to indicate you’d like to activate Laser Ink. 
  2. Open your hand. You should see the Trust Light flashing white to indicate your Ai Pin is scanning for your hand.
  3. Once detected, the Laser Ink Display will project on your hand.
  4. Push out your hand a few more inches until you see the menu.
  5. Pick settings . 
  6. If you see “Software update” pick it. You will then see this message: “Place your Ai Pin and Battery Booster on the charge pad to update overnight.”

NoteIf you don’t see "software update" in the settings menu, your Ai Pin has the most recent software.

Release notes

You can find the release notes for any given update at CosmOS Release and Change Log

We’re here to help