Skip to main content

Ground Control

Answer will appear here...

Back to top

Ai Pin requires your 4-digit passcode to unlock it. For more context on why and when your Ai Pin locks, see Ai Pin lock and unlock behavior.

Change passcode

  1. Tap the touchpad with one finger to indicate you’d like to activate Laser Ink.
  2. Open your hand. You should see the Trust Light flashing white to indicate your Ai Pin is scanning for your hand.
  3. Once detected, the Laser Ink Display will project on your hand.
  4. Push out your hand a few more inches until you see the menu.
  5. Pick settings . 
  6. Scroll and pick “passcode.”
  7. Scroll and pick “change passcode.”
  8. Enter existing passcode.
  9. Enter a new passcode and then re-enter it to verify the change.

Change default lockout period

By default, Ai Pin automatically locks after it detaches from a Booster or accessory. Follow the steps below if you want to change when your Pin to also unlock after a period of inactivity:

  1. Tap the touchpad with one finger to indicate you’d like to activate Laser Ink.
  2. Open your hand. You should see the Trust Light flashing white to indicate your Ai Pin is scanning for your hand.
  3. Once detected, the Laser Ink Display will project on your hand.
  4. Push out your hand a few more inches until you see the menu.
  5. Pick settings . 
  6. Scroll and pick “passcode.”
  7. Scroll and pick “require after.”
  8. Pick a time interval. You can pick 15, 30, or 60 minutes, or “detach only.” (Picking “detach only” causes Ai Pin to lock only when you detach it from Battery Booster.)

Enable "allow swap"

Enable the "allow swap" setting to add a six-second delay when detaching your Pin from an accessory, so you won't need to re-enter your passcode when swapping out accessories. 

  1. Tap the touchpad with one finger to indicate you’d like to activate Laser Ink.
  2. Open your hand. You should see the Trust Light flashing white to indicate your Ai Pin is scanning for your hand.
  3. Once detected, the Laser Ink Display will project on your hand.
  4. Push out your hand a few more inches until you see the menu.
  5. Pick settings . 
  6. Scroll and pick "allow swap" to flip the toggle on .
  7. To confirm, pick "allow swapping."

To disable, pick "allow swap" to flip the toggle off .

Remove passcode

Removing your passcode will reduce the security of your Ai Pin, so proceed at your own risk.

  1. Tap the touchpad with one finger to indicate you’d like to activate Laser Ink.
  2. Open your hand. You should see the Trust Light flashing white to indicate your Ai Pin is scanning for your hand.
  3. Once detected, the Laser Ink Display will project on your hand.
  4. Push out your hand a few more inches until you see the menu.
  5. Pick settings . 
  6. Scroll and pick “passcode.”
  7. Scroll and pick "remove passcode."
  8. Pick "remove."
  9. To confirm, enter your current passcode.

We’re here to help