Skip to main content

Ground Control Beta

Answer will appear here...

Back to top

Ai Pin requires your 4-digit passcode to unlock it.

Change Passcode

  1. Tap the touchpad with one finger to indicate you’d like to activate Laser Ink.
  2. Open your hand. You should see the Trust Light flashing white to indicate your Ai Pin is scanning for your hand.
  3. Once detected, the Laser Ink Display will project on your hand.
  4. Push out your hand a few more inches until you see the menu.
  5. Pick settings . 
  6. Scroll and pick “passcode.”
  7. Scroll and pick “change passcode.”
  8. Enter existing passcode.
  9. Enter a new passcode and then re-enter it to verify the change.

Change lockout period

By default, Ai Pin automatically locks after it detaches from a Booster or accessory. Follow the steps below if you want your Pin to also unlock after a period of inactivity:

  1. Tap the touchpad with one finger to indicate you’d like to activate Laser Ink.
  2. Open your hand. You should see the Trust Light flashing white to indicate your Ai Pin is scanning for your hand.
  3. Once detected, the Laser Ink Display will project on your hand.
  4. Push out your hand a few more inches until you see the menu.
  5. Pick settings . 
  6. Scroll and pick “passcode.”
  7. Scroll and pick “require after.”
  8. Pick a time interval. You can pick 15, 30, or 60 minutes, or “detach only.” (Picking “detach only” causes Ai Pin to lock only when you detach it from Battery Booster.)

We’re here to help